
Add the data drive
The data drive is the location where you install the ePolicy Orchestrator software. Use a remote drive
that all nodes in your cluster can access.
Task
1
Right-click the ePO Application Group and select Add Storage.
2
In the Add Storage dialog box, select the data drive to be used for your ePolicy Orchestrator
installation then click OK.
Install ePolicy Orchestrator software on each node
Run the Cluster installation on each of the nodes. To make sure that each node has exclusive access to
the quorum and data drives during installation, shut down all other nodes in the cluster.
Task
1
Double-click Setup.exe in the installation folder.
2
Follow the wizard until you reach the Setup Type page, then select the Cluster option, then click Next.
3
In the Choose Destination Location page, specify the path for the shared data drive, then click Next.
Use this same path for each node.
4
On the first node in the Set Virtual Server Settings page, provide this identifying information for
the McAfee ePO cluster:
• The ePolicy Orchestrator Virtual Server IP address
• The ePolicy Orchestrator Virtual Cluster name
• The ePolicy Orchestrator Virtual Cluster FQDN
This information is automatically provided on subsequent nodes.
5
Complete the installation on the first node.
6
For each node in your cluster, repeat this task.
Create the Generic Service resources
The Generic Service resources enable the cluster server to control the McAfee ePO server, by starting
and stopping the ePolicy Orchestrator services.
Add three Generic Service resources for use with your clustered McAfee ePO server. Use this table and
task to configure each resource. Create the resources in the order they are listed in the table.
Installing McAfee ePolicy Orchestrator
Perform cluster installation
2
McAfee ePolicy Orchestrator 5.1.0 Software Installation Guide
27
Comentarios a estos manuales