
Task
1
Follow these steps to remove the front bezel.
a
Unlock the bezel if it is locked.
b
Remove the left end of front bezel from rack handle.
c
Rotate the front bezel anticlockwise to release the latches on the right end from the rack
handle.
Figure 2-13 Removing front bezel
2
Follow these steps to install the front bezel.
a
Lock the right end of the front bezel to the rack handle
b
Rotate the front bezel clockwise until the left end clicks into place
c
Lock the bezel if needed.
Figure 2-14 Installing front bezel
Connect the network cable
Task
1
Plug a Category 5e or 6 Ethernet cable in the management port, which is located in the back panel.
2
Plug the other end of the cable into the corresponding network device.
Configure network information for McAfee Advanced Threat
Defense Appliance
After you complete the initial installation and configuration, you can manage the McAfee Advanced
Threat Defense Appliance from a remote computer or terminal server. To do so, you must configure
the McAfee Advanced Threat Defense Appliance with the required network information.
2
Setting up the McAfee Advanced Threat Defense Appliance
Setting up McAfee Advanced Threat Defense
28
McAfee Advanced Threat Defense 3.0.4 Product Guide
Comentarios a estos manuales