McAfee M4050 - Network Security Platform Guía de usuario descargar pdf (Pagina 25)

Remove a module

Perform these tasks if you need to remove an SFP or XFP module.

Task

Disconnect the network fiber-optic cable from the module.

Release the module from the slot by pulling the bail clasp out of its locked position.

Slide the module out of the slot.

Insert the module plug into the module optical bore for protection.

Power on the Sensor

Before you begin

Do not attempt to power on the Sensor until you have installed the Sensor in a rack, made

all necessary network connections, and connected the power cable to the power supply.

If you are installing a redundant power supply, you should install it as described in Installing a power

supply. For true redundant operation with the optional redundant power supply, McAfee recommends

that you plug each supply into a different power circuit.

Task

Connect the power cable to the Sensor power supply.

Connect the power cable to a power source.

The Sensor has no power switch. It powers on as soon as one of its power cable is connected to a

power source.

Power off the Sensor

McAfee recommends that you use the shutdown CLI command to halt the Sensor before powering it

down. For more information on CLI commands, see McAfee Network Security Platform CLI Guide.

Setting up the Sensor

Power on the Sensor

McAfee

Network Security Platform M-3050/M-4050 Sensor Product Guide

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 41 42

Sin comentarios

McAfee M4050 - Network Security Platform Guía de usuario Pagina 25