McAfee M4050 - Network Security Platform Guía de usuario descargar pdf (Pagina 3)

Install modules in the Sensor's Monitoring ports.

2 Cabling the Management and Console ports

Ensure the Sensor is powered OFF before attaching cables.

Plug a Category 5e Ethernet cable in the Mgmt port.

Plug the other end of the cable into the

network device connected to your

Manager server.

Plug the DB9 Console cable supplied in

the Sensor box into the Console port

(labeled Console on the Sensor front

panel).

Connect the other end of the Console

port cable directly to a COM port of the

PC or terminal server you will be using

to configure the Sensor (for example, a

PC running correctly configured Windows HyperTerminal software). You must connect directly to

the console for initial configuration; you cannot configure the Sensor remotely.

The required settings for HyperTerminal are:

• Baud rate: 38400 • Stop Bits: 1

• Number of Bits: 8 • Control Flow: None

• Parity: None

Plug the female end of a power cable into the power inlet and plug the other end into a power

source. The Sensor ships with standard US power and international cables.

The M-3050/M-4050 does not have a power switch; you need to only plug the power

cable into a power source.

1 2 3 4 5 6 7 8 ... 11 12

Sin comentarios

McAfee M4050 - Network Security Platform Guía de usuario Pagina 3