McAfee M-2750 - Network Security Platform Guía de usuario descargar pdf (Pagina 9)

Twenty small form-factor pluggable (SFP) 1 Gigabit Monitoring ports, which enable you to

monitor ten Ethernet segments In-Line.

If you choose to run in failover mode, port 10A is used to interconnect with a standby M-2750

Sensor.

The gigabit ports of the M-2750 running in in-line mode fail-close, meaning that if the Sensor fails, it

will interrupt/block data flow. Refer to the Gigabit Fail-Open Bypass Kit Guide for more information.

One External Compact Flash port. This port is used only for flash recovery purposes. That is,

this port is used in troubleshooting situations where the Sensor's internal flash is corrupted and

you need to reboot the Sensor through the external compact flash. For more information, see the

on-line KnowledgeBase at http://mysupport.mcafee.com/Eservice/. Click Search the KnowledgeBase.

Front panel LEDs. The LEDs which indicate the Sensor's general operational status. For more

information, see Front and back panel LEDs.

Primary Power Supplies—PWR A (included). Power supply A is included with each Sensor. The

supply uses a standard IEC port (IEC320-C13). McAfee provides a standard; 2m NEMA 5-15P (US)

power cable (3 wire). International customers must procure a country-appropriate power cable.

Power Supplies—PWR B (optional, purchased separately). Power supply B is a hot-swappable,

redundant power supply. This power supply also uses a standard IEC320-C13 port, and you can

use the McAfee-provided cable or acquire one that meets your specific needs.

Back panel LEDs. The LEDs which indicate the Sensor's fan and power supply operational status.

For more information, see Front and back panel LEDs.

Sin comentarios

McAfee M-2750 - Network Security Platform Guía de usuario Pagina 9